Saturday, October 20, 2012
Rear shock tower
I know I am slow, but these rear shock tower/roll bar mounts take some time to make. Still need to make the back plate, fully weld it, then weld it to the frame.
Social Profiles
-
First things first. Always ware your safety gear. I didn't even notice this disk come apart until I turned off the angle grinder. Tho... -
I got tired of the miter saw turning metal into scrap and dust. So today I made a trip to Northern Tool and picked up a dry saw http://www.... -
I think this one is going to work. It's just tacked together for now and I still need to add bracing, but you get the idea. -
This is the other car that takes my time and money. And a few of us packing up after a weekend at Roebling Road -
Started on the rear upper control arm. This one is getting close to done. Still need to add the top plate, shock mount, weld in the thread... -
Rear section starting to look like something. Using the 2x1 in the middle of the seat back meant I had to do some math to get the angle rig... -
I wanted to add to the saw review a bit now that I have made a number of cuts with it. Again I am using the Northern Industrial Dry Cut Me...
-
Starting to look like something. I have some 3/4" DOM on order to make the upper and lower rear panel tubes. Not sure how I am going ... -
Started making the rear panel section. I first made this out of 3/4" DOM tube and tacked it in place. To make the bend I used a Home ...
